View IPv6 Statistics on an Interface
View IPv6 statistics to view information about the IPv6 datagrams on an interface.
Procedure
Variable Definitions
Use the data in the following table to use the show ipv6 interface statistics command
|
Variable |
Value |
|---|---|
|
gigabitethernet {slot/port[/sub-port]} |
Identifies a single slot and port. If the platform supports channelization and the port is channelized, you must also specify the sub-port in the format slot/port/sub-port. |
|
loopback <1–256>> |
Identifies a loopback interface. |
|
tunnel <1-2000> |
Identifies a 6in4 tunnel ID. |
|
vlan <1-4059> |
Shows statistics for the specific interface index. If you do not specify an interface index, the command output includes all IPv6 interfaces. Specifies the VLAN ID in the range of 1 to 4059. By default, VLAN IDs 1 to 4059 are configurable and the system reserves VLAN IDs 4060 to 4094 for internal use. On switches that support the vrf-scaling and spbm-config-mode boot configuration flags, if you enable these flags, the system also reserves VLAN IDs 3500 to 3998. VLAN ID 1 is the default VLAN and you cannot create or delete VLAN ID 1. |
|
vrf WORD<1–16> |
Specifies the VRF name. |
|
vrfids WORD<0–512> |
Specifies the VRF ID. |